![]() Finally, we tested it with a new XMON unit at the same time, and it runs well, it didn't mute automatically.Īnyone had this problem before? Look forward to receive all of your advise. I have combined them all into a single video. We have also checked that the XMON cable run properly without hard bending. You will find all the available training videos that I could find on learning the ICON D-Command. Then, we get back to normal again, the D-Command status shows "XMON ON" and we can hear the audio from the speakers.īut this is only remain for a while, it leads to a situation following a self mute (without pressing mute), where the D-command indicates that it is muted but audio is coming out of the monitors and we cannot change the volume adjustment via the volume knob or either change the speaker input selection (the volume and the speaker input selection are remain to our choice before the self mute occurs), or alternatively (following a mute press but not adjustment) where the D-command indicates it is unmuted but no audio emanates from the monitors. But sometimes it does not work, hence we did turn power OFF and ON again on the XMON unit. Sometimes, you can wiggle the volume knob then release the mute button again to be able to hear the audio again. This happens intermittently, at intervals from a few seconds to a few minutes, regardless of whether Pro Tools is running. Welcome to the D-Command® worksurface for Avid® ICON systems. ( a ) ( b ) FIGURE 18.4 DAW on - screen mixer. Then, we tried to release the mute button on the D-Command, but still there is no audio out from the speaker although Pro Tools is running with audio signals on Master Fader. ( b ) Digidesign ICON D- Command Integrated console ( courtesy of Avid Technology, Inc. The XMON has been automatically muting its monitor section, it appears on the D-Command status "XMON OFF". We have a customer who recently had a XMON problem. Hey everyone, Wanted to get your thoughts on doing an upgrade from a 24 fader D-command to a 16 fader D-Control.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |